Planar Auditorium Seating Specifications 19
Planar Specifications – Theatre Seating
PART 3 – OPTIONS
3.1 END PANEL
A.
Provide manufacturer’s standard end panel at the end of the row. The configuration of the panel shall
follow the angle of the frame and back at the rear, and shall be vertical at the front end. The panel shall be
con
structed of 3/4” thick plywood with veneer on both sides and 1/8” thick solid wood on the vertical edges.
The end panel shall be stained to match the outer wood seat, back, and armrests.
3.2 AISLE LIGHT
A.
Aisle lights shall be provided in accordance
to the locations shown on the architectural drawings. The units
shall be of low voltage (24v) type and the light tube shall fit into a routed area on the underside of the
armrest. The chair frame shall be prepared to accept the power wire. The necessary access holes and
blank cover plates shall be provided. The chair manufacturer shall also provide the necessary
transformers. All wiring and electrical connections shall be conducted at the job site and shall be the
responsibility of others.
3.3 HARDWOOD EDGES, OUTER SEAT AND BACK
A. Outer plywood panels shall be trimmed in 1/8” thick hardwood on the top and vertical edges. The
hardwood shall match the face veneer species and be stained to match.
3.4 INSET UPHOLSTERY, BACK
A.
Back upholstery shal
l be inset to expose the veneer face on the inside of the outer back panel. The veneer
on the inside face on the back panel shall match the veneer species on the outside face and be stained to
match.
3.5 SEAT AND ROW IDENTIFICATION TAGS
A. Provide manufacturer’s standard shape brass number and letter plates. Font shall be Times Roman. The
size of the font on the seat number plates shall be 27pt; the size of the font on the row letter plates shall be
42pt. The number plates shall fit into a recessed area at the top edge of the seat. The row letter plates
shall fit into a recessed area at the back of the armrest.
3.6 REMOVABLE CHAIR
A.
Provide the manufacturer’s standard one, two or three chair removable units which shall include an
integrated steel sled-
base that is engineered to conform to the row radii and includes two through holes per
chair for floor mounting.
3.7 FREESTANDING REMOVABLE CHAIR
A. Provide manufacturer’s standard freestanding removable chair which shall include an integrated steel sled-
base that is engineered to conform to the row radii and includes extended length floor plates to allow the
chairs to remain stable with no physical attachment to the floor.
3.8 TABLET ARMS
A. Tablet arm shall be two-motion fold-away style, constructed of 1/2” medium density fiberboard, faced two
sides with matte black high-pressure laminate. The edges shall be finished with a vinyl T-molding trimmed
flush with both top and bottom surfaces.
3.9 BOOKRACK
A.
The bookrack shall be constructed of hardwoods and hardwood plywood. Bookrack shall be assembled
with tongue and groove construction and finished with a catalyzed lacquer.
The bookrack shall be attached
to the outer surface of the chair back. An optional attachment configuration shall consist of a steel
weldment attached to the chair leg. This configuration allows the bookrack to be located between chair
backs.
3.10 COMPLIANCE WITH CALIFORNIA TECHNICAL BULLETIN 133
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels