Teatro A1 Specifications – Theatre Seating
Page 4 of 5
.
Provide manufacturer’s standard freestanding removable chair which shall include an integrated steel sled-
base that is engineered to conform to the row radii and includes extended length floor plates to allow the
chairs to remain stable with no physical attachment to the floor.
3.8 TABLET ARMS
.
Tablet arm shall be two-motion fold-away style, constructed of 1/2” medium density fiberboard, faced two
sides with matte black high-pressure laminate. The edges shall be finished with a vinyl T-molding trimmed
flush with both top and bottom surfaces.
3.9 POWER/DATA
.
Where indicated on the drawings, chair frames shall be equipped with a 115v/15amp power outlet and a
RJ-45 Category 6 data port located on the front of the armrest gusset. Wire raceways shall be provided for
routing of the wires from chair to chair. All wiring and electrical connections shall be conducted at the job
site and shall be the responsibility of others.
3.10 BOOKRACKS
.
The bookrack shall be constructed of hardwoods and hardwood plywood. Bookrack shall be assembled
with tongue and groove construction and finished with a catalyzed lacquer. The bookrack shall be attached
to the outer surface of the chair back. An optional attachment configuration shall consist of a steel
weldment attached to the chair leg. This configuration allows the bookrack to be located between chair
backs.
3.11 COMPLIANCE WITH CALIFORNIA TECHNICAL BULLETIN 133
PART 4 – WARRANTY
4.1
The theater seating manufacturer must provide a Lifetime Warranty to the original purchaser of the seating as
follows:
.
The seating manufacturer shall warrant it’s products against failures and manufacturing defects for the life
of the product. This warranty applies to the original purchaser and is non-transferable. The seating
manufacturer will provide parts and labor to replace defective parts for the first two years after the
installation. Thereafter, the manufacturer will provide replacement parts for the life of the product.
B.
This warranty shall not cover damage from abuse, misuse, neglect, or act of God. Damage caused by
modifications to the product by anyone other than a TSI authorized seating installation technician will void
this warranty. This warranty does not apply to fabrics or products not installed by TSI authorized seating
installation technicians.
PART 5 - EXECUTION
5.1 EXAMINATION
.
Examine site conditions, with installer present, for compliance with requirements for construction tolerances
as they affect anchors and fasteners, and location of junction boxes.
B. Do not proceed until unsatisfactory conditions have been corrected.
5.2 GENERAL
. Comply with seating manufacturer’s printed installation instructions applicable to products.
B. Locate seating in locations indicated on approved shop drawings, with required clearances.
C.
Install standards in locations conforming to seating layout, with each standard attached to substrate by no
less than two anchoring devices of size and type required to insure that chairs are stable under conditions
of actual use.
D.
Install chairs using manufacturer’s recommended hardware and fasteners. Insure that chairs in curved
rows are installed on proper radius and are oriented toward the center point of the radius. Verify that
moving components operate smoothly and quietly.
5.3
DJUSTING
.
djust as required to assure that the seats in each row are aligned when in the upright position.
B.
Touch-up minor abrasions and imperfections in painted finishes with coating that matches factory-applied
finish.
(73 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels