Theatre-solution Jury Base Seating Manuel d'utilisateur télécharger pdf (Page 30)

Lecture Seating Specifications 29

Lecture Seating Specifications

(This section pertains to all models of Lecture Seating.)

PART 4 – WARRANTY

4.1 The lecture seating manufacturer must provide a Warranty to the original purchaser of the seating as follows:

Seat/Table Supports, Worksurfaces, and Modesty Panels – The manufacturer shall warrant it’s products

against failures and manufacturing defects for the life of the product. This warranty applies to the original

purchaser and is non-transferable. The manufacturer will provide parts and labor to replace defective parts

for the first two years after the installation. Thereafter, the manufacturer will provide replacement parts for

the life of the product.

Chair Uppers – The manufacturer shall warrant the product for five (5) years from the date of shipment.

This warranty applies to the original purchaser and is non-transferable. The manufacturer will provide parts

and labor to replace defective parts.

This warranty shall not cover damage from abuse, misuse, neglect, or act of God. Damage caused by

modifications to the product by anyone other than an authorized seating manufacturer technician will void

this warranty. This warranty does not apply to fabrics or products not installed by authorized seating

manufacturer technicians.

PART 5 - EXECUTION

5.1 EXAMINATION

Examine site conditions, with installer present, for compliance with requirements for construction tolerances

as they affect anchors and fasteners, and location of junction boxes.

B. Do not proceed until unsatisfactory conditions have been corrected.

5.2 GENERAL

. Comply with seating manufacturer’s printed installation instructions applicable to products.

B. Locate seating in locations indicated on approved shop drawings, with required clearances.

Install standards in locations conforming to seating layout, with each standard attached to substrate by no

less than two anchoring devices of size and type required to insure that chairs are stable under conditions

of actual use.

Install chairs using manufacturer’s recommended hardware and fasteners. Insure that chairs in curved

rows are installed on proper radius and are oriented toward the center point of the radius. Verify that

moving components operate smoothly and quietly.

5.3

DJUSTING

djust as requi

ed to assure that the seats in each row are aligned when in the closed position.

Touch-up minor abrasions and imperfections in painted finishes with coating that matches factory-applied

finish.

C. Replace any upholstery that has been damaged during installation.

END OF SPECIFICATION

® Herman Miller, Aeron, Equa 2, Pellicle, and Kinemat are among the registered trademarks of Herman Miller, Inc.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 72 73

Pas de commentaire

Theatre-solution Jury Base Seating Manuel d'utilisateur Page 30